2025 Nissan Murano TSBs
11 manufacturer communications for the 2025 Nissan Murano sit in NHTSA's public file. A TSB is factory repair guidance, not a recall — the repair is not automatically free. The 2025 Murano problem report covers complaints, recalls, and investigations.
What the bulletins cover
Service bulletins
FUEL FILLER TUBE LOWER SEAL IS LEAKING AND DTC P0456 IS STORED IN THE ECM This bulletin is no longer active. Please discard previous versions of NTB26-006.
MIL ON WITH DTC P0181 STORED IN THE ECM IF YOU CONFIRM The customer states the MIL is ON but the vehicle does not have any drivability concerns or reduced power message in the combination meter, AND DTC P0181 for “Fuel Tank Temperature” is stored in either “Past” or “Current” in…
CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These…
CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These…
ENGINE NO START WITH KEY SYSTEM ERROR AND DTC B2C20-24 STORED IN THE BCM IF YOU CONFIRM The customer states the engine will not start and “Key System Error” warning is displaying in the Information Display (Combination Meter) (Figure 1), AND DTC B2C20-24 for "STARTER CONTROL…
FUEL FILLER TUBE LOWER SEAL IS LEAKING AND DTC P0456 IS STORED IN THE ECM IF YOU CONFIRM The vehicle has a visible leak with a smoke machine test coming from the fuel filler tube lower seal, AND DTC P0456 is stored as “Active”, “Past”, or “Pending” in the ECM. ACTION 1. Remove…
VENT CONTROL VALVE IN ACTIVE TEST INOPERATIVE IN CONSULT 4 SERVICE INFORMATION An issue in CONSULT 4 has been identified in “EVAP system close” in Work support. · After selecting the "EVAP system close" in Work support, the “VENT CONTROL/V” in Active test becomes non-functional…
ACTION Date: October 2, 2025 To: FOMs, DOMs, RAMs, & RGMs Subject: LAUNCH PD172 PMA55 Multi Model Monroney Bumper Label – QA – Dealer Announcement and Procedure ACTION: FOMs & DOMs are asked to ensure that dealers are aware of this new campaign information. Dealer Announcement:…
CLICKING NOISE WHEN OPENING DRIVER DOOR SERVICE INFORMATION If a popping / clicking noise is present from one or more of the Door Check Links (Figure 1) when opening the associated door: First confirm that the torque of the door side mounting bolts of the related Door Check Link…
ECM REPLACEMENT PROCEDURE REQUIRED FOR RES EQUIPPED VEHICLES SERVICE INFORMATION If any of the APPLIED VEHICLES equipped with Remote Engine Start (RES) requires Engine Control Module (ECM) replacement, the Body Control Module (BCM) must be replaced also at the same time. If you…
LICENSE PLATE FRAME INTERFERENCE TO REAR BUMPER IF YOU CONFIRM A license plate frame does not sit flush and is making contact at bottom edge when installed to the Rear Bumper, as shown in Figure 1 and Figure 2. Figure 1 Figure 2 ACTION Refer to the SERVICE PROCEDURE in this…
Every number on this page is a count of records in the federal complaint, recall, and investigation files published by NHTSA's Office of Defects Investigation. Check any specific vehicle's open recalls by VIN at nhtsa.gov/recalls.